2. PCB Board Assembly

FBX Robot Curriculum, Module No. 1

For this step, you will need the following parts:

If your PCB U-Holder (FBX-11) doesn't already have the four PCB studs (FBX-12) screwed into it, screw the four PCB studs onto the PCB U-Holder as shown here:

Next, place four M3-washers (FBX-28) on each of the four PCB studs as shown here:

Now, place the PCB Board (FBX-32) on top of the PCB studs, and use another four PCB studs to secure the PCB Board into place as shown here:

Next, following the perforated lines, fold the sides of the PCB U-Holder up by 90 degrees as shown here:

Next, take the clear plastic PCB Top Cover (FBX-13) and attach it to the studs atop the PCB Board using four M3x6mm Allen Screws (FBX-21) as shown here: